Search results
Results From The WOW.Com Content Network
The end of the tape is attached to a perpendicular leader pin that is used by an LTO drive to reliably grasp the end of the tape and mount it in a take-up reel inside the drive. Older single-reel tape technologies, such as 9-track tape and DLT, used different means to load tape onto a take-up reel. When a cartridge is not in a drive, the pin is ...
A tape drive is a data storage device that reads and writes data on a magnetic tape. Magnetic-tape data storage is typically used for offline, archival data storage. Tape media generally has a favorable unit cost and long archival stability. A tape drive provides sequential access storage, unlike a hard disk drive, which provides direct access ...
Early IBM tape drives, such as the IBM 727 and IBM 729, were mechanically sophisticated floor-standing drives that used vacuum columns to buffer long u-shaped loops of tape. Between servo control of powerful reel motors, a low-mass capstan drive, and the low-friction and controlled tension of the vacuum columns, fast start and stop of the tape ...
The cartridges contain a single reel and the tape is pulled out of the cartridge by means of a leader tape attached to the take-up reel inside the drive. The drive leader tape is buckled to the cartridge leader during the load process. Tape speed and tension are controlled electronically via the reel motors; there is no capstan. The tape is ...
9-track tape drive used with DEC minicomputers Inside a 9-track tape drive. The vacuum columns are the two gray rectangles on the left. A typical 9-track unit consists of a tape transport—essentially all the mechanics that moves tape from reel to reel past the read/write and erase heads—and supporting control and data read/write electronics.
These drives used Advanced Metal Evaporated (AME) tape with a 2 m integrated cleaning tape header called Smart Clean. 1999—Mammoth-2 12 MB/s data transfer rate; 4.6 cm/s tape speed during normal read/write operations; 1.6 m/s tape speed during search and rewind operations; 17 s load time, from insertion to ready
There are a lot of factors at play when it comes to juicing up your electric car. Here's everything you need to consider when dedicating time to charging an EV.
At the end of the tape, the drive reversed the direction of tape motion, moved the read and write heads slightly vertically across the tape, and continued to write (or read) more data until the beginning of the tape was reached. This process could be repeated many times, laying down several track sets on the tape media in a serpentine recording ...