Ad
related to: sata not detected in bios hp
Search results
Results From The WOW.Com Content Network
BIOS: Phoenix BIOS. Memory: 4 GB maximum, 2 slots DDR2, 1.8 volt unbuffered, asymmetric or interleaved operation supported. Storage: 1 internal SATA drive bay, accepts 2.5 inch hard disk drives and solid state drives; Optical Drive: LightScribe SuperMulti 8X DVD±RW and 24X CD-RW Combo Drive with Double Layer Support
Prior to the development and ubiquitous adoption of the Plug and Play BIOS standard, an add-on device such as a hard disk controller or a network adapter card (NIC) was generally required to include an option ROM in order to be bootable, as the motherboard BIOS did not include any support for the device and so could not incorporate it into the BIOS's boot protocol.
If there is an immediate need to update the offline attributes, the HDD slows down and the offline attributes get updated. The latest "S.M.A.R.T." technology not only monitors hard drive activities but adds failure prevention by attempting to detect and repair sector errors.
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
First introduced in July 2006, [1] the HP Pavilion dv9000 series was a series of high-definition capable widescreen laptops using the HP Imprint finish. It featured 17.0" 16:10 LCD displays housed in a clamshell-type case, measured 15.16 x 11.65 x 1.57 inches, and weighs anywhere from about 7.7 lb (3.5 kg) to 8.4 lb (3.8 kg).
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module. Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
Historically, most SSDs used buses such as SATA, SAS, or Fibre Channel for interfacing with the rest of a computer system. Since SSDs became available in mass markets, SATA has become the most typical way for connecting SSDs in personal computers; however, SATA was designed primarily for interfacing with mechanical hard disk drives (HDDs), and it became increasingly inadequate for SSDs, which ...
The first bit being high commonly indicates the presence of a drive. The two following bits are typically unused, and driven low. Because this line would be high for all 3 bits when no backplane is connected, an HBA can detect the presence of a back-plane by the second or third bit of the SDataIn being driven low.