Search results
Results From The WOW.Com Content Network
All engines in this family share the same block dimensions and sometimes even the same casting number; the latter meaning engines were of the same block, but with different strokes (e.g., the casting number 3970010 was used by all three engines: 302, 327, and 350). This engine family was updated in 1968 for the use of 2.45 in (62.2 mm) medium ...
Jeep CJ; Jeep Wagoneer/Grand Wagoneer; Kaiser Jeep was purchased by AMC in 1970. The Buick 350 cu in (5.7 L) V8, AMC 232 I6, and AMC 327, 360 V8 engines in the FSJ Wagoneer and trucks used a 'nailhead' pattern TH400—also known as a "unipattern," as it was used by many other manufacturers (including Rolls-Royce and Jaguar) with an adapter ring—from 1965 to 1972.
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6; Cadillac HT4100/4.5/4.9 L V8; Isuzu all 3.2 and 3.5L DOHC V6
In the Camaro, the engine was available only through the high-performance Z/28 option, replacing the 302 cu in (4.9 L) engine designed to compete in Trans Am racing's 305 cu in (5.0 L) class installed in 1967-1969 cars. The LT-1 had an 11.0:1 compression ratio, Holley 780 cu ft/min (22 m 3 /min) 4-barrel carburetor, and solid
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
The Oldsmobile Diesel engine is a series of V6 and V8 diesel engines produced by General Motors from 1978 to 1985. Their design was based on the Olds 350 gasoline engine architecture. A 350 cu in (5.7 L) V8 was introduced in 1978, followed by a 261 cu in (4.3 L) V8 only for the 1979 model year.
Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...
The 5L40-E was designated in either "M82" (rear-wheel drive) or "MX5" (all-wheel drive) versions for service in BMW vehicles from 1999 model year until the design was superseded by (for BMW) the 6L45E and (for all others) the 6L50E series electronic automatic transmissions in 2007 . It is designed for service in vehicles up to 4000 lb (1814 kg ...