When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Thermal conductance and resistance - Wikipedia

    en.wikipedia.org/wiki/Thermal_conductance_and...

    The SI unit of absolute thermal resistance is kelvins per watt (K/W) or the equivalent degrees Celsius per watt (°C/W) – the two are the same since the intervals are equal: ΔT = 1 K = 1 °C. The thermal resistance of materials is of great interest to electronic engineers because most electrical components generate heat and need to be cooled.

  3. Thermal conductivity and resistivity - Wikipedia

    en.wikipedia.org/wiki/Thermal_conductivity_and...

    The thermal conductivity of a material is a measure of its ability to conduct heat.It is commonly denoted by , , or and is measured in W·m −1 ·K −1.. Heat transfer occurs at a lower rate in materials of low thermal conductivity than in materials of high thermal conductivity.

  4. Thermal contact conductance - Wikipedia

    en.wikipedia.org/wiki/Thermal_contact_conductance

    To know whether the thermal contact resistance is significant or not, magnitudes of the thermal resistances of the layers are compared with typical values of thermal contact resistance. Thermal contact resistance is significant and may dominate for good heat conductors such as metals but can be neglected for poor heat conductors such as ...

  5. R-value (insulation) - Wikipedia

    en.wikipedia.org/wiki/R-value_(insulation)

    Installed faced fiberglass batt insulation with its R-value visible (R-21) [1]. The R-value (in K⋅m 2 /W) is a measure of how well a two-dimensional barrier, such as a layer of insulation, a window or a complete wall or ceiling, resists the conductive [2] flow of heat, in the context of construction. [3]

  6. Tog (unit) - Wikipedia

    en.wikipedia.org/wiki/Tog_(unit)

    So that practical clothing may be described conveniently by a range of small integers, the unit of thermal resistance, to be called the “tog”, is the resistance that will maintain a temperature difference of 0.1°C. with a flux of 1 watt per square metre, or in more practical terms, 10°C. with a flux of 1 watt per square decimetre.

  7. Properties of metals, metalloids and nonmetals - Wikipedia

    en.wikipedia.org/wiki/Properties_of_metals...

    The thermal conductivity of silicon is better than that of most metals. [citation needed] A sponge-like porous form of silicon (p-Si) is typically prepared by the electrochemical etching of silicon wafers in a hydrofluoric acid solution. [152] Flakes of p-Si sometimes appear red; [153] it has a band gap of 1.97–2.1 eV. [154]

  8. Glossary of chemistry terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_chemistry_terms

    Also acid ionization constant or acidity constant. A quantitative measure of the strength of an acid in solution expressed as an equilibrium constant for a chemical dissociation reaction in the context of acid-base reactions. It is often given as its base-10 cologarithm, p K a. acid–base extraction A chemical reaction in which chemical species are separated from other acids and bases. acid ...

  9. Thermistor - Wikipedia

    en.wikipedia.org/wiki/Thermistor

    The word thermistor is a portmanteau of thermal and resistor. Thermistors are categorized based on their conduction models. Negative-temperature-coefficient (NTC) thermistors have less resistance at higher temperatures, while positive-temperature-coefficient (PTC) thermistors have more resistance at higher temperatures. [1]