Search results
Results From The WOW.Com Content Network
The operational success of a "Test Shop" program set up at March AFB, California, on 15 September 1957, led to the establishment of the base-level Precision Measurement Equipment Laboratories providing the Air Force with a complete calibration system that could handle the increasingly stringent measurement needs of the new missile and aircraft ...
Endoscopic retrograde cholangiopancreatography (ERCP) is a technique that combines the use of endoscopy and fluoroscopy to diagnose and treat certain problems of the biliary or pancreatic ductal systems. It is primarily performed by highly skilled and specialty trained gastroenterologists.
The Army Physical Fitness Test (APFT) was a test designed to measure the muscular strength, endurance, and cardiovascular respiratory fitness of soldiers in the United States Army. The test contained three events: push-ups, sit-ups, and a two-mile run with a soldier scoring from 0 to 100 points in each event based on performance. A minimum ...
It is a marker of respiratory muscle function and strength, [4] represented by cmH 2 O and measured with a manometer. MIP is an important and noninvasive index of diaphragm strength and an independent tool for diagnosing many illnesses. [5] Typical MIPs in adult males can be estimated from the equation M IP = 142 - (1.03 x Age) cmH 2 O, where ...
As part of the Fit to Fight program, the Air Force adopted a more stringent physical fitness assessment in 2004 and replaced the annual ergo-cycle (stationary bike) test that the Air Force had used for several years. [1] [2] Results are stored in the Air Force Fitness Management System (AFFMS) and accessible via the AF Portal. [3]
The simplest force plates measure only the vertical component of the force in the geometric center of the platform. More advanced models measure the three-dimensional components of the single equivalent force applied to the surface and its point of application, usually called the centre of pressure (CoP), as well as the vertical moment of force ...
In the Knoop test, only the longer diagonal is measured, and the Knoop hardness is calculated based on the projected area of the indent divided by the applied force, also giving test units in kgf/mm 2. The Vickers microindentation test is carried out in a similar manner welling to the Vickers macroindentation tests, using the same pyramid.
The edge crush test is a laboratory test method that is used to measure the cross-direction crushing of a sample of corrugated board.It gives information on the ability of a particular board construction to resist crushing.