Search results
Results From The WOW.Com Content Network
Static routes, connected routes, and routes from dynamic configuration protocols can be redistributed by dynamic routing protocols. For instance, a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network.
The letter "S" indicates that the route is a static route that has, for all intents and purposes, been added manually to the router process by the administrator and installed into the routing table. Router#enable Router#configure terminal Router(config)#ip route 1.1.1.0 255.255.255.0 fastEthernet 0/0 Router(config)#do show ip route
Each routing protocol contains loop-avoidance mechanisms, but the information needed for loops to be avoided is lost when routes are redistributed. For example, a distance-vector routing protocol may prevent loops by the "split-horizon" rule; that is to say, if a router learns a route from a particular interface it will not re-advertise the ...
Router configuration rules may contain static routes. A static route minimally has a destination address, a prefix length or subnet mask, and a definition where to send packets for the route. That definition can refer to a local interface on the router, or a next-hop address that could be on the far end of a subnet to which the router is connected.
Static routes are routes that a network administrator manually configured. Routing tables are also a key aspect of certain security operations, such as unicast reverse path forwarding (uRPF). [ 2 ] In this technique, which has several variants, the router also looks up, in the routing table, the source address of the packet.
Enhanced Interior Gateway Routing Protocol (EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
It does this using internal pre-configured directives, called static routes, or by learning routes dynamically using a routing protocol. Static and dynamic routes are stored in the routing table. The control-plane logic then strips non-essential directives from the table and builds a forwarding information base (FIB) to be used by the ...
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...