Ads
related to: stainless steel joist hanger screws 1 1 2 long nut
Search results
Results From The WOW.Com Content Network
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...
Steel fasteners (grade 2,5,8) - the level of strength; Stainless steel fasteners (martensitic stainless steel, austenitic stainless steel), Bronze and brass fasteners - water proof usage; Nylon fasteners - used for the light material and water proof usage. In general, steel is the most commonly used material of all fasteners: 90% or more. [8]
Joist hanger nail – special nails rated for use with joist hangers and similar brackets. Sometimes called "Teco nails" (1 + 1 ⁄ 2 × .148 shank nails used in metal connectors such as hurricane ties) Lost-head nail – see finish nail; Masonry (concrete) – lengthwise fluted, hardened nail for use in concrete; Oval wire nail – nails with ...
Although the use of steel joist hangers to support floor joists is recommended over a ledger supporting the joists because of house settling and nail separation, they are not required by code in most municipalities. However, toe nailing & end nailing is nowhere near as effective as using hangers to support flooring systems. [7]
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Thus, an M6 screw, which has a pitch of 1 mm, is made by threading a 6 mm shank, and the nut or threaded hole is made by tapping threads into a hole of 5 mm diameter (6 mm − 1 mm). Metric hexagon bolts, screws and nuts are specified, for example, in International Standards ISO 4014, ISO 4017, and ISO 4032. The following table lists the ...