Search results
Results From The WOW.Com Content Network
A nickel–metal hydride battery (NiMH or Ni–MH) is a type of rechargeable battery. The chemical reaction at the positive electrode is similar to that of the nickel–cadmium cell (NiCd), with both using nickel oxide hydroxide (NiOOH). However, the negative electrodes use a hydrogen-absorbing alloy instead of cadmium.
Under certain conditions, some battery chemistries are at risk of thermal runaway, leading to cell rupture or combustion.As thermal runaway is determined not only by cell chemistry but also cell size, cell design and charge, only the worst-case values are reflected here.
A nickel–hydrogen battery (NiH 2 or Ni–H 2) is a rechargeable electrochemical power source based on nickel and hydrogen. [5] It differs from a nickel–metal hydride (NiMH) battery by the use of hydrogen in gaseous form, stored in a pressurized cell at up to 1200 psi (82.7 bar ) pressure. [ 6 ]
The battery is sealed, metal contacts are attached, and an optional button top is applied if the battery is intended to replace an AAA/AA/C/D alkaline battery. A label with the brand name is then applied, or a blank protective label, often green (for Ni-MH) or blue (for Ni-Cd) for a generic or OEM battery.
The C rate is that which would theoretically fully charge or discharge the battery in one hour. For example, trickle charging might be performed at C/20 (or a "20-hour" rate), while typical charging and discharging may occur at C/2 (two hours for full capacity). The available capacity of electrochemical cells varies depending on the discharge rate.
How fast self-discharge in a battery occurs is dependent on the type of battery, state of charge, charging current, ambient temperature and other factors. [2] Primary batteries are not designed for recharging between manufacturing and use, and thus to be practical they must have much lower self-discharge rates than older types of secondary cells.
The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery and the kind of service in which the battery is used. When testing the capacity of a NiMH or NiCd battery a cut-off voltage of 1.0 V per cell is normally used, whereas 0.9 V is normally used as the cut-off voltage of an alkaline cell ...
This list is a summary of notable electric battery types composed of one or more electrochemical cells. Three lists are provided in the table. Three lists are provided in the table. The primary (non-rechargeable) and secondary (rechargeable) cell lists are lists of battery chemistry.