Ads
related to: properly dimensioned drawing system for painting wood frames
Search results
Results From The WOW.Com Content Network
Example of true position geometric control defined by basic dimensions and datum features. Geometric dimensioning and tolerancing (GD&T) is a system for defining and communicating engineering tolerances via a symbolic language on engineering drawings and computer-generated 3D models that describes a physical object's nominal geometry and the permissible variation thereof.
Custom strainers or inner panelings that are fit to the painting and secured with screws, therefore offering strength to the painting and allowing hanging devices to be attached without damaging a painting. [24] Cradling – Cradling refers to the addition of wooden supports or frames on the back of paintings. These slats require flexibility to ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
An engineering drawing is a type of technical drawing that is used to convey information about an object. A common use is to specify the geometry necessary for the construction of a component and is called a detail drawing.
A cutaway drawing is a technical illustration, in which part of the surface of a three-dimensional model is removed in order to show some of the model's interior in relation to its exterior. The purpose of a cutaway drawing is to "allow the viewer to have a look into an otherwise solid opaque object.
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame ...
Example of a cradled panel, mounted on the back of a painting by Aert van der Neer. Example of an oak panel in its original state, the back of a Jan Davidsz. de Heem still life. Cradling is a process used in the restoration and preservation of paintings on wooden panel .
A typical datum reference frame is made up of three planes. For example, the three planes could be one "face side" and two "datum edges". These three planes are marked A, B and C, where A is the face side, B is the first datum edge, and C is the second datum edge. In this case, the datum reference frame is A/B/C.