Ads
related to: metal gripper strips for wood stairs interior walls
Search results
Results From The WOW.Com Content Network
Tack strip being removed from a floor. Tack strip also known as gripper rod, carpet gripper, Smoothedge tackless strip, gripper strip or gripper edge is a thin piece of wood, between 1 and 2 metres (3.3 and 6.6 ft) long and about 3 centimetres (1.2 in) wide, studded with hundreds of sharp nails or tacks used in the installation of carpet.
The wall or ceiling finishing process begins with wood or metal laths. These are narrow strips of wood, extruded metal, or split boards, nailed horizontally across the wall studs or ceiling joists. Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 ...
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
Battens are also used in metal roofing to secure the sheets called a batten-seam roof and are covered with a batten roll joint. [2] Some roofs may use a grid of battens in both directions, known as a counter-batten system, which improves ventilation. Roofing battens are most commonly made of wood or metal, but can be made of other materials.
A "carpet gripper" tack strip, for a fitted carpet. The introduction of tack strip, "tackless strip", "gripper strip", or "Smoothedge" simplified the installation of wall-to-wall carpeting, increasing the neatness of the finish at the wall. Because gripper strips are essentially the same thickness as underlay, using gripper strips yields a ...
The nosing is the protrusion beyond the riser when vertical risers are used, or beyond the back of the tread below, when angled risers or no risers are used. Anti-slip strips or nosings may be applied. These stair parts can be manufactured from a variety of materials including aluminum, vinyl, and wood.