Ads
related to: genny4 vs cat4 2022 pro 3 cable modem and switch set up manual
Search results
Results From The WOW.Com Content Network
V.33 is an ITU-T recommendation for a modem operating as full-duplex on a 4-wire point-to-point leased line allowing bidirectional data transfer at either 14.4 kbit/s. V.34 (09/94) is an ITU-T recommendation (superseded) for a modem, allowing up to 28.8 kbit/s bidirectional data transfer using TCM modulation. Other additional defined data ...
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
Category 4 cable (Cat 4) is a cable that consists of eight copper wires arranged in four unshielded twisted pairs (UTP) supporting signals up to 20 MHz. [1] It is used in telephone networks which can transmit voice and data up to 16 Mbit /s.
Downlink LTE: LTE Category 4 (150 Mbit/s). 2x20 MHz carrier aggregation. Up to 64-QAM; Uplink LTE: LTE Category 4 (50 Mbit/s). 1x20 MHz carrier aggregation. Up to 16-QAM; Chipsets: Snapdragon X5 LTE Modem, Snapdragon 616 processor, Snapdragon 415 processor, Snapdragon 412 processor and Snapdragon 212 processor
A DOCSIS 3.0 cable modem A cable modem termination system (CMTS) A DOCSIS architecture includes two primary components: a cable modem located at the customer premises, and a cable modem termination system (CMTS) located at the CATV headend. [28] The customer PC and associated peripherals are termed customer-premises equipment (CPE). The CPE are ...
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
A category 3 cable. Cat 3 was widely used in computer networking in the early 1990s for 10BASE-T Ethernet and, to a much lesser extent, for 100BaseVG Ethernet, Token Ring and 100BASE-T4. The original Power over Ethernet 802.3af specification supports the use of Cat 3 cable, but the later 802.3at Type 2 high-power variation does not. [8]
However, the function of traffic shaping is more likely done by a Cable Modem or policy traffic switch. A CMTS may also act as a bridge or router. A customer's cable modem cannot communicate directly with other modems on the line. In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and ...