When.com Web Search

  1. Ads

    related to: fluorescent tube t5 vs t8 lighting fixture parts catalog free in the mail order

Search results

  1. Results From The WOW.Com Content Network
  2. Fluorescent-lamp formats - Wikipedia

    en.wikipedia.org/wiki/Fluorescent-lamp_formats

    Running an energy-saving T8 tube with a ballast for T12 will reduce lamp life and can increase energy consumption. [9] Conversely, a T12 tube on a T8 ballast will usually draw too much power and so may burn out the ballast, unless it is within the range that particular ballast can compensate for.

  3. T5 retrofit conversion - Wikipedia

    en.wikipedia.org/wiki/T5_retrofit_conversion

    T5 retrofit conversion can maintain existing lighting levels with the higher efficiency of the T5 lamp. However, with kits that operates the lamp on the existing magnetic ballast, the efficiency drops and the lamp life is considerably shortened, as T5 lamps aren't designed to be operated on mains frequency but only on high frequency.

  4. LED tube - Wikipedia

    en.wikipedia.org/wiki/LED_tube

    LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life. LED tubes are sometimes also referred to as ‘LED fluorescent tubes’.

  5. Electrical ballast - Wikipedia

    en.wikipedia.org/wiki/Electrical_ballast

    It can be incorporated into an existing fluorescent light fixture or mounted remotely outside of it. When power is lost, the ballast will illuminate one or more lamps in the fixture at a reduced output for a minimum of 90 minutes (as required by code). These can be used as an alternative to egress lighting powered by a back-up electrical generator.

  6. Fluorescent lamp - Wikipedia

    en.wikipedia.org/wiki/Fluorescent_lamp

    Fluorescent light fixtures cannot be connected to dimmer switches intended for incandescent lamps. Two effects are responsible for this: the waveform of the voltage emitted by a standard phase-control dimmer interacts badly with many ballasts, and it becomes difficult to sustain an arc in the fluorescent tube at low power levels.

  7. Cove lighting - Wikipedia

    en.wikipedia.org/wiki/Cove_lighting

    Traditionally, cove lighting was installed by using T5 fluorescent tubes. T5 luminaires are an energy-efficient alternative to larger luminaires (such as T8 lamps) because they save on materials. [2] Lighting specialists recommend installing cove lighting at least 18 inches (46 cm) from the ceiling and 6 feet 8 inches (2.03 m) from the floor.