Ad
related to: residential window header span tableexpertwindows.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Headers are usually built to rest on trimmers, also called jacks. Areas around windows are defined by a sill beneath the window, and cripples, which are shorter studs that span the area from the bottom plate to the sill and sometimes from the top of the window to a header, or from a header to a top plate.
Trimmers are installed parallel to the primary floor or ceiling joists and support headers, which run perpendicular to the primary joists. [1] [2] It can also refer to a jack stud that supports a header above a window or door opening. Traditionally, a stud which was less than full length was sometimes referred to as a cripple. [3] [4] [5]
Posts in walls are used at point loads such as long spans near a wide window or sliding door, etc. sleeper or nailer - a stud laid flat to other framing members to provide a point of attachment. sill - a stud sized member forming the base of a window assembly or the base of wall.
A window sill may span the entire width of a wall from inside to outside, as is often the case in basic masonry construction, making it visible on both the interior and exterior of the building. In such a case, the exterior window sill and interior window sill would be two sides of the same structural element.
In the case of windows, the bottom span is referred to as a sill, but, unlike a lintel, does not serve to bear a load to ensure the integrity of the wall. Modern-day lintels may be made using prestressed concrete and are also referred to as beams in beam-and-block slabs or as ribs in rib-and-block slabs.
The pole is marked for the heights from (usually) the floor platform of a building for dimensions such as window sill heights, window top heights (or headers), exterior door heights (or headers), interior door heights, wall gas jet heights (for gas lamps) and the level of the next storey joists. It makes for quick, repeatable measurements ...
Unusual sill framing in a granary of half-timber construction. Long tenons project through the sill plate. Timber sills can span gaps in a foundation. A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in ...
Header bond has courses of headers offset by half a brick. Stack bond consists of bricks laid directly on top of one another with joints aligned. This is a weak bond and is likely to require reinforcement. Garden wall bond has three courses of stretchers then one course of headers. Sussex bond has three stretchers and one header in each course.