Search results
Results From The WOW.Com Content Network
Integrated injection logic (IIL, I 2 L, or I2L) is a class of digital circuits built with multiple collector bipolar junction transistors (BJT). [1] When introduced it had speed comparable to TTL yet was almost as low power as CMOS , making it ideal for use in VLSI (and larger) integrated circuits .
An and-inverter graph (AIG) is a directed, acyclic graph that represents a structural implementation of the logical functionality of a circuit or network.An AIG consists of two-input nodes representing logical conjunction, terminal nodes labeled with variable names, and edges optionally containing markers indicating logical negation.
Truth table 2-2 OAI INPUT ... OAI-gates can efficiently be implemented as complex gates. An example of a 3-1 OAI-gate is shown in the figure below. [1] Examples of use
This results in increased speed, reduced power, smaller area, and potentially lower fabrication cost. For example, a 2-1 AOI gate can be constructed with 6 transistors in CMOS, compared to 10 transistors using a 2-input NAND gate (4 transistors), an inverter (2 transistors), and a 2-input NOR gate (4 transistors).
Schematic of basic two-input DTL NAND gate. R3, R4 and V− shift the positive output voltage of the input DL stage below the ground (to cut off the transistor at low input voltage). Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic.
There are many offshoots of the original 7432 OR gate, all having the same pinout but different internal architecture, allowing them to operate in different voltage ranges and/or at higher speeds. In addition to the standard 2-input OR gate, 3- and 4-input OR gates are also available. In the CMOS series, these are: 4075: triple 3-input OR gate
The left diagram above show the construction of a 2-input NOR gate using NMOS logic circuitry. If either of the inputs is high, the corresponding N-channel MOSFET is turned on and the output is pulled low; otherwise the output is pulled high through the pull-up resistor. In the CMOS implementation on the right, the function of the pull-up ...
An AND gate requires two or more inputs that are true for there to be an outcome. As an example, let's say that 1 and 2 are true and 0 is false the only way for there to be an output is for the input to contain either 1,2, or both [ clarify ] . [ 7 ]