Ads
related to: mushroom ventilation for flat roof fan motor
Search results
Results From The WOW.Com Content Network
Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.
Diagramatic operation of a thermal wheel Ljungström Air Preheater by Swedish engineer Fredrik Ljungström (1875–1964). A thermal wheel, also known as a rotary heat exchanger, or rotary air-to-air enthalpy wheel, energy recovery wheel, or heat recovery wheel, is a type of energy recovery heat exchanger positioned within the supply and exhaust air streams of air-handling units or rooftop ...
An attic fan installed underneath a roof A powered attic ventilator , or attic fan , is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used.
Because axial fans are designed to blow air straight down at the floor, they can be used in ceiling and roof structures over 100 ft. tall. Because axial destratification fans can achieve destratification with low CFMs, it is imperative that the air leaving the nozzle achieve an air speed at the floor of between 0.2 and 0.5 m/s.
An axial belt-drive exhaust fan serving an underground car park. This exhaust fan's operation is interlocked with the concentration of contaminants emitted by internal combustion engines. Mechanical ventilation of buildings and structures can be achieved by the use of the following techniques: Whole-house ventilation; Mixing ventilation
Industrial exhausters – This is a relatively inexpensive, medium-duty, steeply inclined flat-bladed fan for exhausting gases, conveying chips, etc. Pre-engineered fans (PE) – A series of fans of varying blade shapes that are usually available in only standard sizes. Because they are pre-engineered these fans may be available with relatively ...