Ad
related to: exair vortex tube enclosure cooler parts manual
Search results
Results From The WOW.Com Content Network
The vortex tube, also known as the Ranque-Hilsch vortex tube, is a mechanical device that separates a compressed gas into hot and cold streams. The gas emerging from the hot end can reach temperatures of 200 °C (390 °F), and the gas emerging from the cold end can reach −50 °C (−60 °F). [ 1 ]
Molecules flow into the tube (to the left) when the pressure in the tube is low (it is sucked into the tube via X 3, coming from the orifice and the buffer). Upon entering the tube, it has the temperature T H. Later in the cycle, the same mass of gas is pushed out from the tube again when the pressure inside the tube is high.
Recuperative multi-tube coolers essentially exist of a turning rotor which is mostly driven via chain. At the ends of the rotor are stiff cases for product feed and outlet. The rotor is supported on running treads, as it is typical for rotary drums. The interior of the rotor exists of several tubes in a revolvertype (or planetary) arrangement.
This page was last edited on 15 November 2005, at 23:32 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
A high-speed rotating (air)flow is established within a cylindrical or conical container called a cyclone. Air flows in a helical pattern, beginning at the top (wide end) of the cyclone and ending at the bottom (narrow) end before exiting the cyclone in a straight stream through the center of the cyclone and out the top.
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
However, the earth can be used to partially cool and dehumidify the replacement fresh air intake for passive-solar thermal buffer zone [5] areas like the laundry room, or a solarium / greenhouse, especially those with a hot tub, swim spa, or indoor swimming pool, where warm humid air is exhausted in the summer, and a supply of cooler drier ...
A Scientific Industries Inc. Vortex-Genie 2 vortex mixer in operation A vortex mixer , or vortexer , is a simple device used commonly in laboratories to mix small vials of liquid. It consists of an electric motor with the drive shaft oriented vertically and attached to a cupped rubber piece mounted slightly off-center.