When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Wow and flutter measurement - Wikipedia

    en.wikipedia.org/wiki/Wow_and_flutter_measurement

    While wow is perceived clearly as pitch variation, flutter can alter the sound of the music differently, making it sound ‘cracked’ or ‘ugly’. A recorded 1 kHz tone with a small amount of flutter (around 0.1%) can sound fine in a ‘dead’ listening room, but in a reverberant room constant fluctuations will often be clearly heard.

  3. Wow (recording) - Wikipedia

    en.wikipedia.org/wiki/Wow_(recording)

    Scrape flutter—a high-frequency flutter of above 1000 Hz—can sometimes occur from the tape vibrating as it passes over a head, as a result of rapidly interacting stretch in the tape and stiction at the head. It adds a roughness to the sound that is not typical of wow and flutter, and damping devices or heavy rollers are sometimes employed ...

  4. Comparison of analog and digital recording - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_analog_and...

    Wow and flutter are a change in frequency of an analog device and are the result of mechanical imperfections. Wow is a form of flutter that occurs at a slower rate. Wow and flutter are most noticeable on signals which contain pure tones. For LP records, the quality of the turntable will have a large effect on the level of wow and flutter.

  5. Flutter (electronics and communication) - Wikipedia

    en.wikipedia.org/wiki/Flutter_(electronics_and...

    In electronics and communication, flutter is the rapid variation of signal parameters, such as amplitude, phase, and frequency.Examples of electronic flutter are: Rapid variations in received signal levels, such as variations that may be caused by atmospheric disturbances, antenna movements in a high wind, or interaction with other signals.

  6. Audio system measurements - Wikipedia

    en.wikipedia.org/wiki/Audio_system_measurements

    The frequency range often specified for audio components is between 20 Hz to 20 kHz, which broadly reflects the human hearing range. Well-designed solid-state amplifiers and CD players may have a frequency response that varies by only 0.2 dB between 20 Hz to 20 kHz. [4]

  7. Purr - Wikipedia

    en.wikipedia.org/wiki/Purr

    A purr or whirr is a tonal fluttering sound made by some species of felids, ... Mean frequency were between 19.3 Hz and 20.5 Hz in ingressive phases, and between 21.9 ...

  8. Reel-to-reel audio tape recording - Wikipedia

    en.wikipedia.org/wiki/Reel-to-reel_audio_tape...

    Digital reel-to-reel tape eliminated all the traditional quality limitations of analog tape, including background noise (hiss), high frequency roll-off, wow and flutter, pitch error, nonlinearity, print-through, and degeneration with copying, but the tape media was even more expensive than professional analog open reel tape, and the linear ...

  9. Audio equipment testing - Wikipedia

    en.wikipedia.org/wiki/Audio_equipment_testing

    Objectivists claim that digital sound can have higher fidelity than analog sound because it lacks clicks, pops, wow, flutter, audio feedback, degradation, generational loss, and rumble, has a higher signal-to-noise ratio, has a wider dynamic range, has less total harmonic distortion, and has a flatter and more extended frequency response.