Search results
Results From The WOW.Com Content Network
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
A crossed helical gear is a gear that operate on non-intersecting, non-parallel axes. The term crossed helical gears has superseded the term spiral gears. There is theoretically point contact between the teeth at any instant. They have teeth of the same or different helix angles, of the same or opposite hand.
A 4WD manual transmission found in many Toyota trucks. Land Cruiser II, Land Cruiser Prado Toyota 4runner and Hilux Surf (1989-1995) 2L-T series and 1KZ series Turbo Diesel, V6 3VZE and 5VZ-FE (also Japan, UK and Europe 1KZ/TE 4Runner 89–95)
1962–1993 New Process Gear NP435 — 4-speed longitudinal manual; 1987–1991 New Process Gear NP535 (also known as New Venture Gear NV2500) — 5-speed longitudinal manual; New Venture Gear NV1500 — 5-speed longitudinal manual; 1994–2004 New Venture Gear NV3500 — 5-speed longitudinal manual 2000–2004 New Venture Gear NV3550
Roto's disadvantage was the 2-3 range or 1-2 gear change because it is not only a huge ratio jump from 2-3 range or 1-2 shift from 2.93 to 1.56, but also there is no fluid slippage in the coupling because the coupling drains (four-tenths of a second) to engage or apply the front clutch and so the trans goes to full mechanical connection.
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications.
After its introduction in 1984, the Justy was also available with 4WD and thus a different gearbox. The gear ratios for this gearbox were altered slightly. In 1994 the normal/FWD gearbox was dropped; one could only get a 4WD gearbox by then. Gear ratios: 1st 3.071 2nd 1.695 3rd 1.137 4th .771 5th .631, Rev 3.461 Final 5.200
AMC 20s have an 8 7/8" ring gear and use a 29 spline axle shaft. The AMC 20 was most often used with V8 engines in cars and Jeeps . It was also used in the AM General Humvee .