Search results
Results From The WOW.Com Content Network
The power factor in a single-phase circuit (or balanced three-phase circuit) can be measured with the wattmeter-ammeter-voltmeter method, where the power in watts is divided by the product of measured voltage and current. The power factor of a balanced polyphase circuit is the same as that of any phase. The power factor of an unbalanced ...
Some devices, including uninterruptible power supplies (UPSs), have ratings both for maximum volt-amperes and maximum watts. A common prefixed derived unit is "kilovolt-ampere" (symbol kVA). The VA rating is limited by the maximum permissible current, and the watt rating by the power-handling capacity of the device.
The maximum power measured is the nominal power of the module in Watts. Colloquially, this is also written as "W p"; this format is colloquial as it is outside the standard by adding suffixes to standardized units. The nominal power divided by the light power that falls on the module (area x 1000 W/m 2) is the efficiency.
equivalent to approximately 114 megawatts of constant power output. The watt-second is a unit of energy, equal to the joule. One kilowatt hour is 3,600,000 watt seconds. While a watt per hour is a unit of rate of change of power with time, [iii] it is not correct to refer to a watt (or watt-hour) as a watt per hour. [36]
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts.The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated (with the rest of the electrical power being converted to heat).
Equipment data sheets and nameplates will often abbreviate power factor as "" for this reason. Example: The active power is 700 W and the phase angle between voltage and current is 45.6°. The power factor is cos(45.6°) = 0.700. The apparent power is then: 700 W / cos(45.6°) = 1000 VA. The concept of power dissipation in AC circuit is ...
Power factor; Elapsed time; The power setting displays instantaneous power, and the kilowatt-hour setting displays energy consumed since last reset. When electricity is disconnected, the P4400's measurements and meters are reset. [6] To reset Kill A Watt models that store values, press Volt and Amp together, or press the Reset key in some models.
A McIntosh stereo audio amplifier with output power of 50 watts per channel used in home component audio systems in the 1970s. [1] Amplification means increasing the amplitude (voltage or current) of a time-varying signal by a given factor, as shown here.