Search results
Results From The WOW.Com Content Network
Irradiation is the process by which an object is exposed to radiation. An irradiator is a device used to expose an object to radiation, notably gamma radiation , for a variety of purposes. [ 1 ]
Radiation is often categorized as either ionizing or non-ionizing depending on the energy of the radiated particles. Ionizing radiation carries more than 10 electron volts (eV), which is enough to ionize atoms and molecules and break chemical bonds. This is an important distinction due to the large difference in harmfulness to living organisms.
In radiometry, irradiance is the radiant flux received by a surface per unit area. The SI unit of irradiance is the watt per square metre (symbol W⋅m −2 or W/m 2).The CGS unit erg per square centimetre per second (erg⋅cm −2 ⋅s −1) is often used in astronomy.
Kerma ("kinetic energy released per unit mass") is used in radiation metrology as a measure of the liberated energy of ionisation due to irradiation, and is expressed in grays. Importantly, kerma dose is different from absorbed dose, depending on the radiation energies involved, partially because ionization energy is not accounted for.
Effective isotropic radiated power is the hypothetical power that would have to be radiated by an isotropic antenna to give the same ("equivalent") signal strength as the actual source antenna in the direction of the antenna's strongest beam. The difference between EIRP and ERP is that ERP compares the actual antenna to a half-wave dipole ...
Thermal creep in irradiated materials is negligible, by comparison to the irradiation creep, which can exceed 10 −6 sec −1. [12] The mechanism is not enhanced diffusivities, as would be intuitive from the elevated temperature, but rather interaction between the stress and the developing microstructure.
Thermal irradiation is the rate at which radiation is incident upon a surface per unit area. [22]: 771 It is measured in watts per square meter. Irradiation can either be reflected, absorbed, or transmitted. The components of irradiation can then be characterized by the equation + + =
That model calculates an effective radiation dose, measured in units of rem, which is more representative of the stochastic risk than the absorbed dose in rad. In most power plant scenarios, where the radiation environment is dominated by X-or gamma rays applied uniformly to the whole body, 1 rad of absorbed dose gives 1 rem of effective dose. [5]