Search results
Results From The WOW.Com Content Network
cubic foot per minute CFM [citation needed] ≡ 1 ft 3 /min = 4.719 474 432 × 10 −4 m 3 /s: cubic foot per second ft 3 /s ≡ 1 ft 3 /s = 0.028 316 846 592 m 3 /s: cubic inch per minute in 3 /min ≡ 1 in 3 /min = 2.731 177 3 × 10 −7 m 3 /s cubic inch per second in 3 /s ≡ 1 in 3 /s = 1.638 7064 × 10 −5 m 3 /s: cubic metre per second ...
Gases are compressible, which means that a figure in cubic feet per minute cannot necessarily be compared with another figure when it comes the mass of the gas. To further confuse the issue, a centrifugal fan is a constant CFM device or a constant volume device. This means that, provided the fan speed remains constant, a centrifugal fan will ...
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
Typically, mass air flow measurements are expressed in the units of kilograms per second (kg/s) or feet per minute (fpm), which can be converted to volume measurements of cubic metres per second (cumecs) [1] or cubic feet per minute (cfm). [2]
The IEEE symbol for the cubic foot per minute is ft 3 /min. [1] The following abbreviations are used: cu ft/min; cufm; cfm or CFM; cfpm or CFPM; Cubic feet per minute is used to measure the amount of air that is being delivered, and is a common metric used for carburetors, [3] pneumatic tools, and air-compressor systems. [4]
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
Q = Volumetric flow rate of air in cubic feet per minute (cfm) Vol = Space volume L × W × H, in cubic feet; In metric units = where: ACPH = number of air changes per hour; higher values correspond to more ventilation; Q = Volumetric flow rate of air in liters per second (L/s)
Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units. The standard temperature for metric measurement is 15 degrees Celsius (i.e. 59 degrees Fahrenheit) while for English measurement the standard temperature is 60 °F.