Search results
Results From The WOW.Com Content Network
It contributed to the casting needs provided by Saginaw Metal Casting Operations and Defiance Foundry. After the Corvair was cancelled the factory switched to casting the engine block and cylinder heads for the Chevrolet 2300 engine used in the Chevrolet Vega GM H platform , the Iron Duke engine used in both the GM N platform and GM L platform ...
In the past when it was called GM-Saginaw Product Company (SPC) a cloverleaf casting symbol mark was cast onto the iron component. [1] [2] The location has been the primary source of engine block and cylinder heads for all of GM's engines, to include Oldsmobile, Pontiac, Cadillac, Chevrolet, Buick and GMC for most of the 20th century.
Starting around 1925 engine blocks and cylinder heads were now developed at each brand but were cast at Saginaw Metal Casting Operations. [3] In the mid-1960s, there were 8 separate families of GM V8 engines on sale in the USA. [4] [1] By the 1970s, GM began to see problems with their approach.
GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983). These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing.
These engines vary in displacement between 2.8 and 3.4 litres (2,837 and 3,350 cc) and have a cast-iron block and either cast-iron or aluminum heads. Production of these engines began in 1980 and ended in 2005 in the U.S., with production continued in China until 2010. This engine family was the basis for the GM High Value engine family.
Romulus Engine plant entrance. Romulus Engine is an automobile engine plant in Romulus, Michigan.Opened in 1976, the factory produces engines for General Motors vehicles. The factory receives cast engine blocks from Defiance Foundry in Defiance, Ohio and Saginaw Metal Casting Operations in Saginaw, Michigan.
The head casting number (which can be viewed from the passenger side of the vehicle just in front of the valve cover) was 706. Some heads with this casting number would fail (but not all of them) as GM had different suppliers for the same head. The failure was due to undetected porosity around the oil drains in the head. [93]
Like all other GM divisions, Olds continued building its own V8 engine family for decades, adopting the corporate Chevrolet 350 small-block and Cadillac Northstar engine only in the 1990s. All Oldsmobile V8s were assembled at plants in Lansing, Michigan while the engine block and cylinder heads were cast at Saginaw Metal Casting Operations.