When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Powder coating - Wikipedia

   en.wikipedia.org/wiki/Powder_coating

   Heat-sensitive carbon fiber tubes coated with a UV curable powder coating. Powder coating is a type of coating that is applied as a free-flowing, dry powder.Unlike conventional liquid paint, which is delivered via an evaporating solvent, powder coating is typically applied electrostatically and then cured under heat or with ultraviolet light.

3. Electrostatic coating - Wikipedia

   en.wikipedia.org/wiki/Electrostatic_coating

   Integrated into a powder paint booth is a powder recovery unit, which recovers between 95% and 100% of the paint over-spray coatings. After the workpiece is coated, it continues on the conveyor belt to an oven, where the paint is cured. The benefits to the process of electrostatic coating are the ability to recover the little over-spray and ...

4. Abradable powder coatings - Wikipedia

   en.wikipedia.org/wiki/Abradable_powder_coatings

   The coating acts as a sacrificial layer when it comes in contact with another surface so that the base material underneath is protected and remains unharmed. [2] [3] Abradable Powder Coatings safely reduce operating clearances and friction to improve the efficiency of compressors, pumps, engines, blowers, etc.

5. Thermal spraying - Wikipedia

   en.wikipedia.org/wiki/Thermal_spraying

   A powder feed stock is injected into the gas stream, which accelerates the powder up to 800 m/s. The stream of hot gas and powder is directed towards the surface to be coated. The powder partially melts in the stream, and deposits upon the substrate. The resulting coating has low porosity and high bond strength. [1]

6. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   The molten powder ‘flows’ into the profile and bonds with the steel. The molten powder will become a solid coating, when the ‘gel time’ is over, which usually occurs within few seconds after coating application. The resin part of coating will undergo cross-linking, which is known as “curing” under the hot condition.

7. Abradable coating - Wikipedia

   en.wikipedia.org/wiki/Abradable_coating

   An abradable coating is a coating made of an abradable material – meaning if it rubs against a more abrasive material in motion, the former will be worn whereas the latter will face no wear. Abradable coatings provide a .1 to .2% performance improvement compared to those without coating.