Ads
related to: atx power supply on pins diagram labeled youtube tv
Search results
Results From The WOW.Com Content Network
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
12V only power connector (labelled P1, though it is not compatible with the ATX 20 or 24 pin connector): This is a 10 or 16-pin Molex connector supplying the motherboard with three or six 12 V lines with common returns, a 'supply OK' signal, a 'PSU ON' signal and a 12 or 11 V auxiliary supply. One pin is left unused.
ATX12VO power supply connector Color Signal Pin Pin Signal Color Green PS_ON# 1 6 PWR_OK: Gray Black COM 2 7 +12 VSB Purple Black COM 3 8 +12 V1 DC Yellow Black COM 4 9 +12 V1 DC Yellow TBD Reserved 5 10 +12 V1 DC Voltage Sensing Pin Yellow
The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power. Modern, ATX ...
Derived from the EEB and ATX specifications. microATX: Intel: 1996 244 × 244 mm (9.6 × 9.6 in) A 20 % shorter variant of the ATX form factor. Compatible with most ATX cases, but has fewer slots than ATX, for a smaller power supply unit. Very popular for desktop and small form factor computers as of 2017. Mini-ATX: AOpen: 2005
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
A wiring diagram for parts of an electric guitar, showing semi-pictorial representation of devices arranged in roughly the same locations they would have in the guitar. An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing.