Ads
related to: dth drilling tools
Search results
Results From The WOW.Com Content Network
DTH drill tool operated with drilling mud (Drillstar MUDHammer) A down-the-hole drill, usually called DTH by most professionals, is basically a jackhammer screwed on the bottom of a drill string. The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or drilling mud). The DTH hammer is one ...
Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...
Titanium drilling. Drilling is a cutting process where a drill bit is spun to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute.
Cable tool drilling was developed in ancient China and was used for drilling brine wells. The salt domes also held natural gas, which some wells produced and which was used for evaporation of the brine. Drake learned of cable tool drilling from Chinese laborers in the U.S. [4] The first primary product was kerosene for lamps and heaters.
The Ditch Witch organization specializes in the design and manufacture of underground construction equipment. The company is a source for trenchers, vibratory plows, horizontal directional drilling systems, drill pipe, downhole tools, vacuum excavation systems, fluid management systems, and mini skid steers. Because of its extensive experience ...
Push-the-bit tools use pads on the outside of the tool which press against the well bore thereby causing the bit to press on the opposite side causing a direction change. Point-the-bit technologies cause the direction of the bit to change relative to the rest of the tool by bending the main shaft running through it.