Ads
related to: porter cable plunge router base
Search results
Results From The WOW.Com Content Network
Porter-Cable was founded in 1906 in Syracuse, New York, by R.E. Porter, G.G. Porter, and F.E. Cable, who invested $2,300 in a jobbing machine and tool shop the trio ran out of a garage. In 1914, the company began to focus on power tools, starting with a line of lathes .
There are two standard types of router—plunge and fixed. When using a plunge-base router, the sole of the base is placed on the face of the work with the cutting bit raised above the work, then the motor is turned on and the cutter is lowered into the work. With a fixed-base router, the cut depth is set before the tool is turned on. The sole ...
The saw base can be adjusted for depth of cut and can tilt up to 45° and sometimes 50° in relation to the blade. Adjusting the depth of cut helps minimize kickback. Different diameter blades are matched to each saw and are available ranging from 14 to 61 centimetres (5.5–24.0 in).
A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only in that they swap the positions of pairs 2 and 3 – the only pairs used by the formerly common 10BASE-T and 100BASE-TX – a cable with T568A wiring at one end and T568B at the other functions as a ...
A revision of base standard incorporating 802.3ae, 802.3ak and errata 802.3an: 2006: 10GBASE-T 10 Gbit/s Ethernet over copper twisted pair cable 802.3ap: 2007: Backplane Ethernet, 1 and 10 Gbit/s over printed circuit boards (10GBASE-KR and 10GBASE-KX4) 802.3aq: 2006: 10GBASE-LRM 10 Gbit/s Ethernet over multi-mode fiber with enhanced ...
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.