Search results
Results From The WOW.Com Content Network
Industrial and consumer packages other than boxes can also be subjected to compression testing: drum, pail, bottle, tub [1] etc. Package components are also evaluated for compression resistance. [2] It is usually a laboratory test involving a special machine, a compression tester, to apply controlled compression on a test specimen.
Typical lectromechanical Universal Testing Machine Test fixture for three point flex test. A universal testing machine (UTM), also known as a universal tester, [1] universal tensile machine, materials testing machine, materials test frame, is used to test the tensile strength (pulling) and compressive strength (pushing), flexural strength, bending, shear, hardness, and torsion testing ...
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
Tensile testing, also known as tension testing, [1] is a fundamental materials science and engineering test in which a sample is subjected to a controlled tension until failure. Properties that are directly measured via a tensile test are ultimate tensile strength , breaking strength , maximum elongation and reduction in area. [ 2 ]
Compression set A is defined as the percentage of original specimen thickness after the specimen has been left in normal (uncompressed) conditions for 30 minutes. C A, the compression set A is given by C A = [(t o - t i) / t o] * 100 where t o is the original specimen thickness and t i is the specimen thickness after testing. [2]
For compression testing, two symmetrical bars are situated in series, with the sample in between. The incident bar is struck by a striker bar during testing. The striker bar is fired from a gas gun. The transmitted bar collides with a momentum trap (typically a block of soft metal). Strain gauges are mounted on both the incident and transmitted ...
Compression tests should normally be done with all spark plugs removed to maximize cranking speed. Cranking compression is a dynamic test of the actual low-speed pumping action, where peak cylinder pressure is measured and stored. A compression tester. Leak-down testing is a static test. Leak-down tests cylinder leakage paths.
The edge crush test is a laboratory test method that is used to measure the cross-direction crushing of a sample of corrugated board.It gives information on the ability of a particular board construction to resist crushing.