Search results
Results From The WOW.Com Content Network
Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).
To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.
Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal , paper , vulcanized fibre and some forms of plastic sheet.
A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]
Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A wall-sized display sample of a punch card for the 1954 U.S. Census of Agriculture. ANSI INCITS 21-1967 (R2002), Rectangular Holes in Twelve-Row Punched Cards (formerly ANSI X3.21-1967 (R1997)) Specifies the size and location of rectangular holes in twelve-row 3 + 1 ⁄ 4-inch-wide (83 mm) punched cards.
The lower image is a plain plug gauge used to check the size of a hole; the green end is the go, and the red end is the no-go. The tolerance of the part that this gauge checks is 0.30 mm, where the lower size of the hole is 12.60 mm and the upper size is 12.90 mm, every size outside this range is out of tolerance. This may be initially ...