When.com Web Search

  1. Ads

    related to: wire lath screws for concrete

Search results

  1. Results From The WOW.Com Content Network
  2. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

  3. Lath - Wikipedia

    en.wikipedia.org/wiki/Lath

    Self-furring lath is an expanded metal lath which is dimpled to hold itself off from a solid surface; Wire lath is made from welded or woven wires and is similar to hardware cloth; Paper backed wire lath is wire lath with building paper attached; Strip laths is metal lath that is several inches wide and is often used to reinforce joints and on ...

  4. Anchor bolt - Wikipedia

    en.wikipedia.org/wiki/Anchor_bolt

    Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

  5. Stucco - Wikipedia

    en.wikipedia.org/wiki/Stucco

    A wide variety of stucco accessories, such as weep screeds, control and expansion joints, corner-aids and architectural reveals are sometimes also incorporated into the lath. Wire lath is used to give the plaster something to attach to and to add strength. Types include expanded-metal lath, woven-wire lath, and welded-wire lath.

  6. Lath and plaster - Wikipedia

    en.wikipedia.org/wiki/Lath_and_plaster

    Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.

  7. Expanded metal - Wikipedia

    en.wikipedia.org/wiki/Expanded_metal

    Expanded metal lath used to support stucco (1919) Facade made from expanded metal. Expanded metal is frequently used to make fences, walkways, and grates, as the material is very durable and strong, unlike lighter and less expensive [dubious – discuss] wire mesh. The many small openings in the material allow flow through of air, water, and ...