Search results
Results From The WOW.Com Content Network
Common names: foiled twisted pair, shielded twisted pair, screened twisted pair. This type of shielding helps prevent EMI from entering or exiting the cable. Individual and overall shield (F/FTP, S/FTP, and SF/FTP): Individual shielding using foils for every twisted pair in a cable, and also an outer foil or braided shielding. Common names ...
The original FPD-Link designed for 18-bit RGB video has 3 parallel data pairs and a clock pair, so this is a parallel communication scheme. However, each of the 3 pairs transfers 7 serialized bits during each clock cycle. So the FPD-Link parallel pairs are carrying serialized data, but use a parallel clock to recover and synchronize the data.
Fully Arduino compatible board, that fits perfectly on a Raspberry Pi, and can be programmed through the Raspberry Pi's serial interface. It also breaks out the Raspberry Pi's SPI and I²C interfaces, or can be used as a stand-alone Arduino when powered with the external power header. Romeo 2012 [108] ATmega328 DFRobot [109]
It used a convenient star-wired physical topology and ran over shielded twisted-pair cabling. Shortly thereafter it became the basis for the IEEE 802.5 standard. [8] [failed verification] During this time, IBM argued that Token Ring LANs were superior to Ethernet, especially under load, [9] but these claims were debated. [10]
Twinaxial plug (style used by IBM; [1] other designs exist [2]) Twinaxial cabling, or twinax, is a type of cable similar to coaxial cable, but with two inner conductors in a twisted pair instead of one. [3] Due to cost efficiency it is becoming common in modern (2013) very-short-range high-speed differential signaling applications.
The best practice is to keep data or signal cables physically separated by at least 3 inches (75mm) from 'heavy' power circuits which are in parallel. Analog signal cable used in professional audio applications is usually shielded twisted pair cable terminated in XLR connectors. The twisted pair carries the signal in a balanced audio configuration.
[1] Structured cabling design and installation is governed by a set of standards that specify wiring data centers , offices , and apartment buildings for data or voice communications using various kinds of cable, most commonly Category 5e (Cat 5e), Category 6 (Cat 6), and fiber-optic cabling and modular connectors .
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...