When.com Web Search

  1. Ads

    related to: 3.5mm audio jack connection diagram

Search results

  1. Results From The WOW.Com Content Network
  2. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    They often appeared next to a 3.5 mm microphone jack for a remote control on-off switch on early portable tape recorders; the microphone provided with such machines had the on-off switch and used a two-pronged connector with both the 3.5 and 2.5 mm plugs. They were also used for low-voltage DC power input from wall adapters.

  3. Audio and video interfaces and connectors - Wikipedia

    en.wikipedia.org/wiki/Audio_and_video_interfaces...

    A phone connector (tip, ring, sleeve) also called an audio jack, phone plug, jack plug, stereo plug, mini-jack, or mini-stereo. This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions. There also exists 4.4 mm Pentaconn connectors.

  4. Microphone connector - Wikipedia

    en.wikipedia.org/wiki/Microphone_connector

    Photo: 2.5 mm mono (TS), 3.5 mm mono and stereo (TRS), and 1 ⁄ 4 inch (6.4 mm) stereo (TRS) phone connectors The most common microphone connector in consumer use is the venerable phone connector, in 1 ⁄ 4 inch (6.4 mm), 3.5 mm, and 2.5 mm sizes, and in both mono and stereo configurations.

  5. RCA connector - Wikipedia

    en.wikipedia.org/wiki/RCA_connector

    The RCA connector [3] is a type of electrical connector commonly used to carry audio and video signals. The name RCA derives from the company Radio Corporation of America, which introduced the design in the 1930s. [4] The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [5] or phono ...

  6. List of video connectors - Wikipedia

    en.wikipedia.org/wiki/List_of_video_connectors

    Analog camcorders commonly use a 3.5 mm four-contact TRRS connector to carry composite video and stereo audio. Jack appears identical to more common three-contact stereo audio-only 3.5 mm TRS connector. DisplayPort: DisplayPort (DP) was designed to replace VGA, DVI, and FPD-Link and standardized by VESA. [2] It is primarily used to connect a ...

  7. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced, with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks.

  8. Y-cable - Wikipedia

    en.wikipedia.org/wiki/Y-cable

    A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors , as described below. A Y-cable , Y cable , or splitter cable is a cable with three ends: one common end and two other ends.

  9. Sound card - Wikipedia

    en.wikipedia.org/wiki/Sound_card

    Analog microphone audio input Input 3.5 mm minijack: A microphone Light blue: 284 C Analog line level audio input Input 3.5 mm minijack Arrow going into a circle Lime: 577 C Analog line level audio output for the main stereo signal (front speakers or headphones) Output 3.5 mm minijack Arrow going out one side of a circle into a wave Orange: 157 C