When.com Web Search

  1. Ads

    related to: header bolts that won't back out of top plate and one head

Search results

  1. Results From The WOW.Com Content Network
  2. Chrysler 1.8, 2.0 & 2.4 engine - Wikipedia

    en.wikipedia.org/wiki/Chrysler_1.8,_2.0_&_2.4_engine

    The cause of the problem was found to be one head bolt hole that was drilled too shallow at the factory, meaning the head bolt bottomed out and could never seal properly. In 1998, a thicker, multi-layer steel head gasket was introduced that eliminated this problem. General Specifications. Cylinder Configuration: In-line 4

  3. Slip-critical joint - Wikipedia

    en.wikipedia.org/wiki/Slip-critical_joint

    These bolts, usually tension control bolts or compressible washer tension indicating type bolts, are tensioned to a minimum required amount to generate large enough friction forces between the faying surfaces such that the shear (or tension) load is transferred by the structural members and not by the bolts (in shear) and the connection plates ...

  4. List of GM bellhousing patterns - Wikipedia

    en.wikipedia.org/wiki/List_of_GM_bellhousing...

    Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.

  5. Exhaust manifold - Wikipedia

    en.wikipedia.org/wiki/Exhaust_manifold

    When the exhaust valve opens, the high pressure exhaust gas escapes into the exhaust manifold or header, creating an "exhaust pulse" comprising three main parts: The high-pressure head is created by the large pressure difference between the exhaust in the combustion chamber and the atmospheric pressure outside of the exhaust system

  6. Chevrolet small-block engine (first- and second-generation)

    en.wikipedia.org/wiki/Chevrolet_small-block...

    The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.

  7. Honda VF1000 - Wikipedia

    en.wikipedia.org/wiki/Honda_VF1000

    The VF1000 is a range of motorcycles produced by Honda from 1984 to 1988. The VF1000 is named after its V-4 998 cc (60.9 cu in) double overhead cam 16-valve engine. There were three main models in the VF1000 range, the VF1000F (also known as Interceptor), the VF1000R and the VF1000F2.