Ad
related to: dlc connector how many pins go on ebay
Search results
Results From The WOW.Com Content Network
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors. From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo.
General Motors implemented both a 5-pin connector and a 12-pin connector, with the 12 pin connector (Packard/Delco/Delphi part number 12020043) being used in the vast majority of GM cars. Lotus implemented a 10-pin connector. The pins are given letter designations in the following layouts (as seen from the front of the vehicle connector):
A connector plug with all 60 pins (such as a Molex 88766-7610 DVI-I splitter) does not fit into a properly keyed DMS-59 socket. A Dual-DVI breakout cable can be used in connection with two passive DVI-to-HDMI adapters to feed modern displays with HDMI inputs, while using a DMS-59 graphics card, since the DVI signals are electrically identical ...
AMP Mate-n-Lok and Molex 8981 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors Molex Mini-Fit Jr. connector as used for ATX power supply. A Molex connector is a
AOL latest headlines, entertainment, sports, articles for business, health and world news.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) " IDC header " which has two rows of pins, 0.1 inches (2.54 mm) apart.
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7] A separate connector is provided for DC power. [1]