Ads
related to: dlc connector how many pins go on 5
Search results
Results From The WOW.Com Content Network
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
General Motors implemented both a 5-pin connector and a 12-pin connector, with the 12 pin connector (Packard/Delco/Delphi part number 12020043) being used in the vast majority of GM cars. Lotus implemented a 10-pin connector. The pins are given letter designations in the following layouts (as seen from the front of the vehicle connector):
The desktop computer hard-drive connector (AMP Mate-n-Lok 1-480424-0 power connector) is standard on all 5.25-inch floppy drives, 3.5-inch PATA and non-SCA SCSI disk drives; however, newer SATA disk drives employ a more advanced interconnection with 15 contacts. These advanced connection systems were first developed by Molex and other connector ...
The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors. From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo.
The many types are partly to prevent incorrect connection. [2] The larger connector sizes are the most varied, with designated connectors ranging from analog and digital signals to AC and DC power. [4] Each "coding" has a different keyway that prevents incorrect connection between incompatibly keyed connectors. [5]
Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...
Each slave node has to provide two extra pins, one input, D 1, and one output, D 2. The first SNPD node input D1 is either set to GND or connected to the output of the master. The output of the first node, D 2 , is connected to the input, D 1 of the second node, and so on resulting in a daisy chain.
A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist.