Search results
Results From The WOW.Com Content Network
A range of add-ons are readily available from simple bolt on modifications and suspension parts to complete aftermarket frames and big bore kits to give more power to the engine. The heavily finned, air-cooled Blaster engine has roots from a water-cooled machine (Yamaha DT200), as evidenced by the plugged water pump casting on the right side of ...
An illustration of several key components in a typical four-stroke engine. For a four-stroke engine, key parts of the engine include the crankshaft (purple), connecting rod (orange), one or more camshafts (red and blue), and valves. For a two-stroke engine, there may simply be an exhaust outlet and fuel inlet instead of a valve system.
This engine had many of the same basic dimensions as one of Austin's pre-war sidevalve engines - the 1125cc engine fitted in the Austin 10 which had the 88.9 mm (3.5 in) stroke common to all later B-Series engines, allowing the use of much of the same installed equipment to produce the block and crankshaft - but to an all-new OHV design.
These engines were used by IHC for some heavy-duty applications until 1935, although their own large engines (525 cu in (8.6 L) FBD and 648 cu in (10.6 L) FEB) had appeared in 1932. [6] The medium-duty 1930 A-series trucks received the all-new 278.7 cu in (4.6 L) FB-3 six-cylinder engine, with overhead valves and seven main bearings .
Honda upgraded the two-stroke engine to 342 cc (20.9 cu in) which was later decreased to 329 cc (20.1 cu in) in a recall. [3] The engine was mounted behind the driver, [ 2 ] and featured 6.7:1 compression , capacitor discharge ignition a 32 mm (1.26 in)-throat Keihin carburetor , and added electric starting. [ 2 ]
At the beginning of 1984, Ford Pinto engine displacement range switched from 1.3/1.6/2.0 to 1.6/1.8/2.0. The newly introduced 1.8 L engine used the 2.0 L crankshaft, so to uniform engine parts for the whole range after dropping the 1.3 L — the 1.6 L was redesigned to also take the 2.0 L crankshaft which had a 76.95 mm (3.030 in) stroke.
This engine features a square 83 mm (3.27 in) bore and stroke with a 10.0:1 compression ratio. This engine was built at the Trenton Engine Plant for use in export market (non-US) Chrysler Neons. It produces 86 kW (115 hp) at 5750 rpm and 151 N⋅m (111 lb⋅ft) at 4950 rpm and meets Euro III emission standards. Applications:
By the early 1960s, the Soviet Union's increased need for a more advanced ATV was becoming obvious as the single-unit tracked snow and swamp-going vehicles in operation at that time could not carry payloads in excess of 5 tonnes (4.9 long tons; 5.5 short tons). To fill the need for such vehicles, a specialized design bureau was established with ...