Ads
related to: amps with effects loop
Search results
Results From The WOW.Com Content Network
An effects loop is a series of audio effects units, connected between two points of a signal path (the route that a signal would travel from the input to the output); usually between the pre-amp and power amp stages of an amplifier circuit, although occasionally between two pre-amp stages. The two principal uses of effects loops are in ...
A few Dumble amps have a Dumbleator circuit built in, but most have "un-buffered" input jacks that tap directly out of the pre-amp and into the power amp. Dumble likely created this external loop because of the difficulty of fitting effects loop buffering into the amplifier chassis (and the limited use of effects loops for most players). The ...
A post master volume, transformer coupled, guitar level effects loop is also provided. [10] In addition, the amp contains much of the same circuitry as the original Single Channel non-reverb amp. In 2020 Jim Kelley began building a two channel version of the Line Amp. Unlike the FACS Line Amp, these amps feature two distinct inputs.
Early Bs have an attached power cord, like the A version. Some differences: Version A has no stereo effects loop or footswitch for reverb, and the lead channel is much like the Mark IIC+s. Version B has switchable reverb, a single switchable stereo effects loop, and an output to drive another power amp. Its voicings are altered slightly.
The Power Station serves as a power attenuator, power booster, and reamping device with a passive line out and posts load amp effects loop. The internal power amp response can be adjusted using dedicated Presence and Depth controls based on Fryette's original Depth Control design introduced in 1988. Aether Amplifier. Also introduced in 2014 ...
The 2100/2500 Mark IIIs are essentially JCM800 2203/2204s with added diode clipping controllable via a knob on the front panel and an effects loop. These are fairly uncommon and were not in production for long before being replaced by the 2100/2500 SL-X, which replaced the diode clipping from the Mk III with another 12AX7/ECC83 preamplifier valve.
The power amplifier uses four 6L6GC tubes in the power section in class AB. It has 120 watts RMS output power, into 16, 8 or 4 Ohms. The effects loop can be bypassed with a footswitch. It features separate inputs for both high and low gain. The amplifier has two channels, rhythm and lead.
The amplifier was reissued for the first time in 1988 (the 1959S), and again from 1991 to 1993 (the 1959X) and from 1993 to 1995 (the 1959SLP). [1] The SLP continued after 1995 but in 2000 Marshall added modifications to lower the noise floor (hum balance pot), reverted the negative feedback resistor to the 1968-69 value of 47 kΩ, and added an effects loop.