Ad
related to: milsim operator manual 1 8 6 spline coupler
Search results
Results From The WOW.Com Content Network
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
The coupling transformer has to have a turns ratio of 1:1.41 ± 3.0 percent. The resistors R both have to have a value of 0.75 Zo ± 2.0 percent, where Zo is the characteristic impedance of the bus at 1 MHz.
Normally bus couplers are available with 1.4:1 transformer ratios and 59 ohm (2 watt 1%) resistors. For special applications, couplers can be supplied with different transformer ratios (e.g., 1:1) and other resistance values (e.g., 54.9 ohms). Bus coupler configurations are available as non-terminated or internally terminated.
Nipples with mating safety couplings. Also known as pneumatic couplings, quick disconnects, air couplers, quick connect couplers, and quick couplers, hand-operable air-line fittings allow manual disconnection of gas supply lines, including compressed air and breathable air (a subset of breathing gases).
Manual The operation of this type is done, usually by the use of tools, at the coupler itself. The operator needs to leave the operator's station (usually the cab) to go to the end of the work equipment in order to effect the release of a bucket or attachment, and to do the same in order to attach the next bucket or attachment to be used.
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
The bigger the system/device the more pages are required and more variety of manuals are required. i.e. User manual, Operator manual, Maintainer manual, Spare list, and so on. If some fault has occurred in the system, then the operator may need to refer to more than one manual and it is very difficult to refer to multiple hard copies.
Parallel keys are the most widely used. They have a square or rectangular cross-section. Square keys are used for smaller shafts and rectangular faced keys are used for shaft diameters over 6.5 in (170 mm) or when the wall thickness of the mating hub is an issue.