Search results
Results From The WOW.Com Content Network
While the difficulty of obtaining macroscopic samples of synthetic elements in part explains their high value, there has been interest in converting base metals to gold (Chrysopoeia) since ancient times, but only deeper understanding of nuclear physics has allowed the actual production of a tiny amount of gold from other elements for research ...
In addition to the cost of the water heater, make sure to account for these additional expenses. Permits. Permits for a hot water heater replacement usually cost between $25 and $300, depending on ...
The levelized cost of electricity (LCOE) is a metric that attempts to compare the costs of different methods of electricity generation consistently. Though LCOE is often presented as the minimum constant price at which electricity must be sold to break even over the lifetime of the project, such a cost analysis requires assumptions about the value of various non-financial costs (environmental ...
Water from the system or holding tank is then run over or near this hot element in a pipe or tank, heating the water to a suitable temperature, then making the water hot enough to boil and become saturated steam, [1] at which point the saturated steam is transported to wherever it is needed via the steam pipes that exit the body of the electric ...
L.D. Porta gives the following equation determining the efficiency of a steam locomotive, applicable to steam engines of all kinds: power (kW) = steam Production (kg h −1)/Specific steam consumption (kg/kW h). A greater quantity of steam can be generated from a given quantity of water by superheating it.
The specific heat of the human body calculated from the measured values of individual tissues is 2.98 kJ · kg−1 · °C−1. This is 17% lower than the earlier wider used one based on non measured values of 3.47 kJ · kg−1· °C−1.
The most common type of electrode boiler pumps water from the lower part of the vessel to an internal header that has nozzles that allow the water to flow to electrodes. Generally the working pressure is maintained at 10 bar. If more pressure is needed (more steam) the controls speed up the pump to increase flow through additional nozzles.
A compression ratio of 2 is possible (and sometimes more) but unless the motive steam is at a reasonably high pressure (say, 16 bar g - 250 psig - or more), the motive steam consumption will be in the range of 2 kg per kg of suction vapors. A higher compression ratio means a smaller heat exchanger, and a reduced investment cost.