When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Thermal management (electronics) - Wikipedia

   en.wikipedia.org/wiki/Thermal_management...

   As stated in GR-3028, most equipment environments maintain cool front (maintenance) aisles and hot rear (wiring) aisles, where cool supply air is delivered to the front aisles and hot air is removed from the rear aisles. This scheme provides multiple benefits, including effective equipment cooling and high thermal efficiency.

3. Fan coil unit - Wikipedia

   en.wikipedia.org/wiki/Fan_coil_unit

   These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.

4. HVAC control system - Wikipedia

   en.wikipedia.org/wiki/HVAC_control_system

   The building owner can monitor the system and respond to alarms generated by the system from local or remote locations. The system can be scheduled for occupancy or the configuration can be changed from the BAS. Sometimes the BAS is directly controlling the HVAC components. Depending on the BAS different interfaces can be used. [4]

5. Heating seasonal performance factor - Wikipedia

   en.wikipedia.org/wiki/Heating_seasonal...

   Heating seasonal performance factor (HSPF) is a term used in the heating and cooling industry. HSPF is specifically used to measure the efficiency of air source heat pumps. HSPF is defined as the ratio of heat output (measured in BTUs) over the heating season to electricity used (measured in watt-hours). [1] [2] It therefore has units of BTU ...

6. Chilled beam - Wikipedia

   en.wikipedia.org/wiki/Chilled_beam

   A chilled beam is a type of radiation/convection HVAC system designed to heat and cool large buildings through the use of water. [1] This method removes most of the zone sensible local heat gains and allows the flow rate of pre-conditioned air from the air handling unit to be reduced, lowering by 60% to 80% the ducted design airflow rate and the equipment capacity requirements.

7. Air conditioning - Wikipedia

   en.wikipedia.org/wiki/Air_conditioning

   The turn down ratio depends on the system configuration and manufacturer. It modulates from 15 or 25% up to 100% at full capacity with a single inverter from 12 to 100% with a hybrid tandem. This method is the most efficient way to modulate an air conditioner's capacity. It is up to 58% more efficient than a fixed speed system. [citation needed]