Search results
Results From The WOW.Com Content Network
Figure 1: Basic N-channel JFET common-source circuit (neglecting biasing details). Figure 2: Basic N-channel JFET common-source circuit with source degeneration. In electronics, a common-source amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a voltage or transconductance amplifier.
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.
Top: source, bottom: drain, left: gate, right: bulk. Voltages that lead to channel formation are not shown. In field-effect transistors (FETs), depletion mode and enhancement mode are two major transistor types, corresponding to whether the transistor is in an on state or an off state at zero gate–source voltage.
The JFET (junction field-effect transistor) uses a reverse biased p–n junction to separate the gate from the body. The static induction transistor (SIT) is a type of JFET with a short channel. The DEPFET is a FET formed in a fully depleted substrate and acts as a sensor, amplifier and memory node at the same time.
The operating current of this JFET is typically 0.1 to 0.5 mA and is often referred to as bias, which is different from the phantom power interface which supplies 48 volts to operate the backplate of a traditional condenser microphone. [12] Electret microphone bias is sometimes supplied on a separate conductor. [13]
Figure 1: Basic NPN common-emitter circuit (neglecting biasing details) In electronics, a common-emitter amplifier is one of three basic single-stage bipolar-junction-transistor (BJT) amplifier topologies, typically used as a voltage amplifier. It offers high current gain (typically 200), medium input resistance and a high output resistance.
Channel length modulation (CLM) is an effect in field effect transistors, a shortening of the length of the inverted channel region with increase in drain bias for large drain biases. The result of CLM is an increase in current with drain bias and a reduction of output resistance. It is one of several short-channel effects in MOSFET scaling.
Figure 1: Basic NPN common collector circuit (neglecting biasing details).. In electronics, a common collector amplifier (also known as an emitter follower) is one of three basic single-stage bipolar junction transistor (BJT) amplifier topologies, typically used as a voltage buffer.