Ads
related to: sealing a sunroof that leaks liquid
Search results
Results From The WOW.Com Content Network
In the course of sealing castings against porosity, the parts would be processed through the following four stations: Impregnation Chamber: The operator would seal the chamber and draw a vacuum. This would remove air in the porosity and leak path in the casting wall. Parts would then be covered with sealant, and positive pressure applied.
Washers minimize the risk of seal degradation and cryogenic leaks by eliminating the interface between connected butt ends of wire. Washers are manufactured as a continuous ring with no breaks. [ 9 ] Indium material used must be ultra-pure (99.9 minimum purity) to prevent hardening of the material at sub-zero temperatures, as well as to ...
Weatherstripping is the process of sealing openings such as doors, windows, and trunks from the waters above. The term can also refer to the materials used to carry out such sealing processes. The goal of weatherstripping is to prevent rain and water from entering entirely or partially and accomplishes this by either returning or rerouting water.
The gasses cannot pass through this backer rod and can deform, weaken, and even cause holes (leaks) in the caulk or sealant as it escapes. Out-gassing is the reason that open-cell backer rod was developed. [7] Open-cell foam is porous so it will let gasses through which could otherwise cause blistering of the caulk or sealant.
Seal (emblem), applying a seal to a document for authentication; Sealing wax, a wax material of a seal which, after melting, hardens quickly; Duct sealing, the sealing of leaks in air ducts; Induction sealing, method of heating a metal disk to seal a cap or top on a container; Porosity sealing, the process of filling a porous substrate to make ...
A seal is a device or material that helps join systems, mechanisms or other materials together by preventing leakage (e.g. in a pumping system), containing pressure, or excluding contamination. The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets .