Search results
Results From The WOW.Com Content Network
The role of the constant false alarm rate circuitry is to determine the power threshold above which any return can be considered to probably originate from a target as opposed to one of the spurious sources. If this threshold is too low, more real targets will be detected, but at the expense of increased numbers of false alarms.
The false positive rate is calculated as the ratio between the number of negative events wrongly categorized as positive (false positives) and the total number of actual negative events (regardless of classification). The false positive rate (or "false alarm rate") usually refers to the expectancy of the false positive ratio.
The probability of type I errors is called the "false reject rate" (FRR) or false non-match rate (FNMR), while the probability of type II errors is called the "false accept rate" (FAR) or false match rate (FMR). If the system is designed to rarely match suspects then the probability of type II errors can be called the "false alarm rate". On the ...
An estimate of d′ can be also found from measurements of the hit rate and false-alarm rate. It is calculated as: d′ = Z(hit rate) − Z(false alarm rate), [15] where function Z(p), p ∈ [0, 1], is the inverse of the cumulative Gaussian distribution. d′ is a dimensionless statistic. A higher d′ indicates that the signal can be more ...
Constant False Alarm Rate, a form of Automatic Gain Control (AGC), is a method that relies on clutter returns far outnumbering echoes from targets of interest. The receiver's gain is automatically adjusted to maintain a constant level of overall visible clutter.
Using the sequential analysis ("online") approach, any change test must make a trade-off between these common metrics: . False alarm rate; Misdetection rate; Detection delay; In a Bayes change-detection problem, a prior distribution is available for the change time.
In addition, noise in the radar receiver will occasionally exceed the detection threshold of the radar's Constant false alarm rate detector and be incorrectly reported as targets (known as false alarms). The role of the radar tracker is to monitor consecutive updates from the radar system (which typically occur once every few seconds, as the ...
The false-positive rate is also known as the probability of false alarm [1] and equals (1 − specificity). The ROC is also known as a relative operating characteristic curve, because it is a comparison of two operating characteristics (TPR and FPR) as the criterion changes. [2]