Ads
related to: 2 stroke diesel engine cylinder sleeve puller
Search results
Results From The WOW.Com Content Network
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
All two-stroke diesel engines require artificial aspiration to operate, and will either use a mechanically driven blower or a turbo-compressor to charge the cylinder with air. In the early phase of intake, the air charge is also used to force out any remaining combustion gases from the preceding power stroke, a process referred to as scavenging .
The open end uncovered the exhaust ports high in the cylinder wall at the bottom of the sleeves' stroke, leaving the ports cut into the sleeve to handle the incoming charge only. The sleeves had a stroke of 30% of the piston travel at 1.950 in (49.5 mm) and operated 15 degrees in advance of the crankshaft . [ 5 ]
The Detroit Diesel Series 53 is a two-stroke diesel engine series, available in both inline and V configurations, manufactured by Detroit Diesel as a more compact alternative to the older Series 71 for medium and heavy duty trucks. The number 53 refers to the nominal swept displacement per cylinder in cubic inches.
The 38 8-1/8 engines are inline diesel engines, with combustion occurring between two opposed pistons within a single cylinder liner. The engine has a bore of 8-1/8 inches (206.4 mm), a stroke of 10 inches (254.0 mm) for each piston, and the cylinder height is 38 inches (970 mm). The engine block is of dry block construction. [1]
An unusual form of four-stroke model engine that uses what is essentially a sleeve-valve format, is the British RCV series of "SP" model engines, which use a rotating cylinder liner driven through a bevel gear at the cylinder liner's "bottom", which is actually at the aft end of the cylinder; and, even more unusually, have the propeller shaft ...