Search results
Results From The WOW.Com Content Network
On displays with a fixed refresh rate, a frame can only be shown on the screen at specific intervals, evenly spaced apart. If a new frame is not ready when that interval arrives, then the old frame is held on screen until the next interval (stutter) or a mixture of the old frame and the completed part of the new frame is shown ().
The closest equivalent to a refresh rate on an LCD monitor is its frame rate, which is often locked at 60 fps. But this is rarely a problem, because the only part of an LCD monitor that could produce CRT-like flicker—its backlight—typically operates at around a minimum of 200 Hz.
The original FreeSync is based over DisplayPort 1.2a, using an optional feature that VESA terms Adaptive-Sync. [9] [10] This feature was in turn ported by AMD from a Panel-Self-Refresh (PSR) feature from Embedded DisplayPort 1.0, [11] which allows panels to control its own refreshing intended for power-saving on laptops. [12]
60 fps typically, some gaming monitors can do up to 540 fps; internally, display refreshed at up to 540 fps [18] [19] 60 fps typically, some can do 120 fps; internally, display refreshed at e.g. 480 or 600 fps [20] 60 fps typically. Up to 480 fps. [21] Flicker: Perceptible on lower refresh rates (60 fps and below) [22]
A depiction of 5 display refresh cycles with what may be shown during a micro stuttering case. Each colored section represents one of the GPU's frame buffer and each color change represents a frame buffer swap. Assuming a 60 Hz refresh rate, a benchmark tool may report this as 144 frames per second.
Front and rear views of the TVM MD-3 cathode-ray tube monitor (Enhanced Graphics Adapter era). Note the DE-9 connector, cryptic mode switch, contrast and brightness controls at front, and the V-Size and V-Hold knobs at rear, which allow the control of the scaling and signal to CRT refresh rate synchronization respectively.
A refresh rate of 60 Hz on most screens will produce a visible "flickering" effect. Most people find that refresh rates of 70–90 Hz and above enable flicker-free viewing on CRTs. Use of refresh rates above 120 Hz is uncommon, as they provide little noticeable flicker reduction and limit available resolution.
Flicker-free is a term given to video displays, primarily cathode-ray tubes, operating at a high refresh rate to reduce or eliminate the perception of screen flicker.For televisions, this involves operating at a 100 Hz or 120 Hz hertz field rate to eliminate flicker, compared to standard televisions that operate at 50 Hz (PAL, SÉCAM systems) or 60 Hz (), most simply done by displaying each ...