Ads
related to: half dovetail o-ring groove
Search results
Results From The WOW.Com Content Network
Wedged half-dovetail: a mortise in which the back is wider, or taller, than the front, or opening. The space for the wedge initially leaves room to insert the tenon. The wedge, after the tenon is engaged, prevents its withdrawal. Through-wedged half-dovetail: a wedged half-dovetail mortise that passes entirely through the piece.
A dovetail joint or simply dovetail is a joinery technique most commonly used in woodworking joinery (carpentry), including furniture, cabinets, [1] log buildings, and traditional timber framing. Noted for its resistance to being pulled apart, also known as tensile strength , the dovetail joint is commonly used to join the sides of a drawer to ...
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
Both the seal ring and mating must accommodate secondary sealing elements. In some designs, various retainers, sleeves and other components may also include secondary sealing elements. Whereas a simple O-ring might require only a groove for fitting, some secondary sealing elements (for example, packing) might require mechanical compression.
Left to right: Half lap, mitred half lap, cross lap and dovetail lap. A lap joint or overlap joint is a joint in which the members overlap. Lap joints can be used to join wood, plastic, or metal. A lap joint can be used in woodworking for joining wood together. A lap joint may be a full lap or half lap.
The simple halved joint is created by cutting a slot in opposite edges of the members to be joined so that they slip together. Most commonly, the amount of material removed is equal to half the width of the members being joined, although this depends on the relative dimensions of the members.
This canal may receive a circlip, an o-ring, or a gasket. A depression on the entire circumference of a cast or machined wheel, a pulley or sheave. This depression may receive a cable, a rope or a belt. A longitudinal channel formed in a hot rolled rail profile such as a grooved rail. This groove is for the flange on a train wheel.
O-rings can be placed in a groove or may be used in combination with a centering ring or as a "captured" o-ring that is held in place by separate metal rings. Metal gaskets are used in ultra-high-vacuum systems where outgassing of the elastomer could be a significant gas load. A copper ring gasket is used with ConFlat flanges.