Ads
related to: starbolt old engine parts diagram ph 660132 1
Search results
Results From The WOW.Com Content Network
The diagram, which is not to scale, is a composite of various designs in the late steam era. Some components shown are not the same as, or are not present, on some locomotives – for example, on smaller or articulated types. Conversely, some locomotives have components not listed here.
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
The engine was a single-cylinder unit that displaced 6.1 dm 3, and was rated 3 PS (2,206 W) at 180/min, with a fuel consumption of 0.95 m 3 /PSh (1.29 m 3 /kWh). [ 17 ] : p43-44 Wilhelm Maybach later improved the engine by changing the connecting rod and piston design from trunk to crosshead , so it could be put into series production.
Russell & Co reportedly started building steam traction engines after their 1878 incorporation, and by 1880, they employed 425 people on a seven acre site, with their own railroad sidetrack. [3] By 1884, they had become one of the largest producers of steam traction engines, plus building industrial, railroad and agricultural equipment. [2]
An oscillating cylinder engine cannot be reversed by means of the valve linkage (as in a normal fixed cylinder) because there is none. Reversing of the engine can be achieved by reversing the steam connections between inlet and exhaust or, in the case of small engines, by shifting the trunnion pivot point so that the port in the cylinder lines up with a different pair of ports in the port face.
A typical 6-horsepower (4.5 kW) engine weighs approximately 1,000 pounds (450 kilograms). Typically, the material for all significant engine parts was cast iron. Small functional pieces were made of steel and machined to tolerance. [1] The fuel system of a hit-and-miss engine consists of a fuel tank, fuel line, check valve, and fuel mixer
GMDD developed a widespread international marketing, service, and parts distribution infrastructure for GM diesel engines in the postwar years. In 1962 GM's Electro-Motive Division (EMD), which had its own marketing and service infrastructure from its years in the locomotive business, took over the production and marketing of large diesel ...