Ads
related to: toshiba efuse quick short circuit protection relay
Search results
Results From The WOW.Com Content Network
In computing, an eFuse (electronic fuse) is a microscopic fuse put into a computer chip. This technology was invented by IBM in 2004 [ 1 ] to allow for the dynamic real-time reprogramming of chips. In the abstract, computer logic is generally "etched" or "hard-wired" onto a chip and cannot be changed after the chip has finished being manufactured.
In electric power systems and industrial automation, ANSI Device Numbers can be used to identify equipment and devices in a system such as relays, circuit breakers, or instruments. The device numbers are enumerated in ANSI / IEEE Standard C37.2 Standard for Electrical Power System Device Function Numbers, Acronyms, and Contact Designations .
The relays can also be classified on the type of power source that they use to work. A dual powered protection relay powered by the current obtained from the line by a CT. The striker is also shown. Self-powered relays operate on energy derived from the protected circuit, through the current transformers used to measure line current, for example.
Resettable fuses - PolySwitch devices. A resettable fuse or polymeric positive temperature coefficient device (PPTC) is a passive electronic component used to protect against overcurrent faults in electronic circuits.
On the other hand, replacing a fuse without isolating the circuit first (most building wiring designs do not provide individual isolation switches for each fuse) can be dangerous in itself, particularly if the fault is a short circuit. In terms of protection response time, fuses tend to isolate faults more quickly (depending on their operating ...
Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network. The objective of a protection scheme is to keep the power system stable by isolating only the components ...
Typical contact elements of an electromechanical relay or contactor. A “contact” is a pair of electrodes (typically, one moving; one stationary) designed to control electricity. Electromechanical switches, relays, and contactors “turn power on” when the moving electrode makes contact with the stationary electrode to carry current.
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.