Search results
Results From The WOW.Com Content Network
Using a C-stand safely is a matter of proper technique, and on the job training. When setting and tightening a grip arm, flag or other equipment in the grip head, it is crucial that the gear be set to one side of the grip head such that the weight causes the locking knob to tighten clockwise, or "righty tighty".
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]
A Block and bleed manifold is a hydraulic manifold that combines one or more block/isolate valves, usually ball valves, and one or more bleed/vent valves, usually ball or needle valves, into one component for interface with other components (pressure measurement transmitters, gauges, switches, etc.) of a hydraulic system. The purpose of the ...
Switching between automatic and manual transmission modes is by moving the shift lever to the bottom that then allows upshifts and downshifts by moving the lever left and right. [ 9 ] The system works with shifter down into a gated area on the shift assembly that allows the shifter to be pushed to the right (up-shift) or to the left (down-shift ...
A later innovation, the floatless fill valve, designed for low-profile, low-flow toilet tanks, uses a pressure-sensing diaphragm mechanism instead of a float to control the inlet valve. [4] Delay valves, which delay the filling until the level has dropped to a low level, avert short-cycling of the water supply.
Diaphragm valves (or membrane valves) consists of a valve body with two or more ports, a flexible diaphragm, and a "weir or saddle" or seat upon which the diaphragm closes the valve. The valve body may be constructed from plastic , metal or other materials depending on the intended use.
The four-way valve or four-way cock is a fluid control valve whose body has four ports equally spaced round the valve chamber and the plug has two passages to connect adjacent ports. The plug may be cylindrical or tapered, or a ball.
The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.