When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Heat pump - Wikipedia

   en.wikipedia.org/wiki/Heat_pump

   An air source heat pump (ASHP) is a heat pump that can absorb heat from air outside a building and release it inside; it uses the same vapor-compression refrigeration process and much the same equipment as an air conditioner, but in the opposite direction. ASHPs are the most common type of heat pump and, usually being smaller, tend to be used ...

3. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Heating, ventilation, and air conditioning (HVAC) is the use of various technologies to control the temperature, humidity, and purity of the air in an enclosed space. Its goal is to provide thermal comfort and acceptable indoor air quality .

4. Central heating - Wikipedia

   en.wikipedia.org/wiki/Central_heating

   Hydronic radiant floor heating systems use a boiler or district heating to heat water and a pump to circulate the hot water in plastic pipes installed in a concrete slab. The pipes, embedded in the floor, carry heated water that conducts warmth to the surface of the floor, where it broadcasts heat energy to the room above.

5. Furnace (central heating) - Wikipedia

   en.wikipedia.org/wiki/Furnace_(central_heating)

   In some areas electrical resistance heating is used, especially where the cost of electricity is low or the primary purpose is for air conditioning. Modern high-efficiency furnaces can be up to 98% efficient and operate without a chimney, with a typical gas furnace being about 80% efficient. [ 1 ]

6. Heating system - Wikipedia

   en.wikipedia.org/wiki/Heating_system

   A heating system is a mechanism designed to regulate and maintain a desired temperature within a space by utilizing thermal energy. It is a fundamental component of Heating, Ventilation, and Air Conditioning (HVAC) systems, providing warmth to residential, commercial, and industrial buildings.

7. Crankcase heater - Wikipedia

   en.wikipedia.org/wiki/Crankcase_heater

   Some air conditioning equipment manufacturers install crankcase heaters either in the compressor (insertion type), or mount them externally around the base of the compressor (bellyband type). The two wires of the heater are wired directly to the input side of the contact from the main power supply, and power is always supplied to the heater.