When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks. The quick change drill chucks are easy and fast option to attach the core drills.

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...

4. Apex Tool Group - Wikipedia

   en.wikipedia.org/wiki/Apex_Tool_Group

   Jacob's Chuck – drill chucks; JOBOX – truck boxes and site storage; K-D Tools – mechanic's hand and specialty tools; K&F – files and rasps; Kahnetics – Dispensing systems. Lufkin – Manufactures measuring tools such as calipers, gauges, micrometers, and measuring tapes. Lufkin was Cooper's first hand tool acquisition in 1967.

5. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Drill chucks mounted by Jacobs tapers onto arbors with Morse tapers for the spindle. Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut.

6. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   One particular type of reduced-shank drill bits are Silver & Deming (S&D) bits, whose sets run from 9 ⁄ 16-inch (14 mm) to 1 + 1 ⁄ 2-inch (38 mm) drill body diameter with a standard 1 ⁄ 2-inch (13 mm) reduced shank for all. This allows drill presses with 1 ⁄ 2-inch (13 mm) chucks to run the larger drills. S&D bits are 6 inches (150 mm ...

7. Power tool - Wikipedia

   en.wikipedia.org/wiki/Power_tool

   At this point, the Hole-Shooter, a drill that weighed 5 lbs. was created by A. H. Peterson. The Peterson Company eventually went bankrupt after a devastating fire and recession , but the company was auctioned off to A. F. Siebert, [ 21 ] a former partner in the Peterson Company, in 1924 and became the Milwaukee Electric Tool Company .